|
|
| |
E1 to 10Base-T Protocol Converter
E1 support
Both 75ohm & 120ohm Impedance, unframed
& framed mode
|
|
| |
|
|
|
|
| |
Overview
The device F4-51 Network Bridge is a high performance,
remote, self-learning Ethernet bridge. Its compact
size and low cos t
make it ideal for cost-sensitive bridging applications,
or as a LAN extender over bit stream type infrastructures.
Its E1 data interface also provides an economical
digital access solution for E1 and Fractional E1 network
Services, which can work atdata rates of 64Kbps to
2048Kbps.User data isplaced into the E1 frame, using
only the required number of timeslots. Timeslot assignment
is accomplished according to the Data Port speed and
manual setting of DIP switches. The main E1 link may
be clocked from the recovered receive clock or from
an internal oscillator. For easy to check the fault
of network line, the device provides loop selection,
both local loop and remote loop.
Features |
- High performance bridge for 10Base-T
Ethernet extension
- Fully compatible with IEEE 802.3
and Ethernet Standards
- E1 channel: both framed &
unframed are OK, both 75 & 120ohm are OK
- Ethernet Port: 10Mbps, Full/Half
Duplex Mode compatible
- Ethernet ports support MDI/MDI-X
selectionable
- Allow transmitting and receiving
VLAN data packet
- 15000 frames per second filtering
and forwarding rate
- 1000 MAC address LAN table, and
automatic LAN table learning and aging.
- Standalone and Module optional
- Power of Chassis: 2 Slots for
slide in power supplier module, AC or DC power
supplier module, Redundant Power supported
- AC220V+-20%or DC-48V power
input
Specifications |
- LAN port
Standard: Conforms to IEEE802.3 / 10Base-T Ethernet
Data rate: 10Mbps(20Mbps/10Base-T in Full duplex
topology)
Compatible on Full/Half duplex topology
Connectors: RJ-45 Connector
Transfer distance: <150m
- E1 port
Standard: ITU G.703, G.704,
Jitter Performance: According to ITU G.823
Bit rate: N*64Kbps, N=1~31 (Fractional Mode) or
2.048Mbps(Full Mode)
Line Code: HDB3
Line Impedance: 75/120ohms optional
Pulse Amplitude: Nominal 2.37V+-10%
General |
- Voltage: AC 220V+-20%or DC -48V
- Power Consumption: <3 Watts
- Temperature: 0-50oC
- Humidity: 0-90%(non-condensing)
- Size: (Width: from left
to right)
Standalone: 272mm(Width)*139mm(Deep)*41mm(High)
Chassis: 438mm(Width)*252mm*Deep)*178mm(High)
Typical
Application
Order Information
F4-51A E1 to 10Base-T Protocol Converter, standalone,
220VAC power supply
F4-51D E1 to 10Base-T Protocol Converter, standalone,
-48VDC power supply
F4-51M E1 to 10Base-T Protocol Converter, Module
|
|
| |
|
|
